| Rectagrid & Gripweld – Welding Standards |
|
|
|
|
|
|
|
|
|
Kickplate Welded to Transverse Bars |
|
Kickplate Welded to The Bearer Bar |
|
|
The top half of each transverse bar is welded to the kickplate.
At approximately 300mm intervals, the transverse bar is replaced by a stiffener which is seal welded to the bearer bar and kickplate. |
|
|
A gap of 3 to 5mm is allowed between the bearer bar and the kickplate. This gap is to allow adequate corrosion protection in cases where special finishes are required.
A weld of 20 to 30mm long at approximately every 300mm is run alternatively top and bottom |
|
|
|
|
|
|
|
|
|
Kickplate Welded to Bearer Bars at 90° |
|
Banding Welded to Transverse Bars |
|
|
|
|
Corners are welded on one side.
An appropriate weld is made on one side only, at approximately every fourth bearer bar |
|
|
|
Corners are welded on one side.
Every fourth bearer bar is welded with an appropriate weld. |
|
|
|
|
|
|
|
|
|
|
Banding Welded to Transverse Bars |
|
Width Joining of Rectagrid Panels |
|
|
At appropriate intervals the transverse bar is replaced by a stiffener which is welded to the banding.
The top of every alternate transverse bar is welded to the banding. |
|
|
A gap is left between the transversals.
At appropriate intervals the transverse bar is replaced by a stiffener which is welded to the bearer bar.The first transversal is welded on the top only. |
|
|
|
|
|
|
